A couple of important things to note during setup. First, for the contact sensor, be sure to have the magnets aligned, otherwise it won’t work. We learned this the hard way after spending an hour troubleshooting. Second — and this is really important – depending on where you live, you may need to get a permit for the system from a local government agency. Ring helps you navigate through this process by looking up your address and telling you whether a permit is required.
I’ve enjoyed reading your summaries for over a year. I initially had my mind set on Abode after removing iSmartAlarm and SimpliSafe (previous generation) from consideration. I had an Abode package all set and nearly pulled the trigger on a purchase. However, after coming across Ring and reading your review multiple times, I ultimately went with Ring. What won me over was the package being offered by Costco that has six door/window sensors. When I priced out what Abode would cost to have comparable coverage, Ring clearly won out. I don’t need any integrations or automation, thus I don’t feel I’m losing out on those aspects by selecting Ring over Abode.
In addition to sharing camera access, having multiple users will make geofencing even more intelligent. The cameras will arm when everyone is away and disarm when at least one person is home. You can also see who is home and who is away using the mobile app and set up Presence notifications to alert you of the same. Finally, it brings everyone in on the action. If an event is detected, an alert will be sent to all users. If one user responds to the alert, other users will be able to see how that person responded. You can also leave a comment on the event and chat with other users directly within the app.
The original Ring has a battery option. I don’t know how I would feel about that because you do have to remove the doorbell to charge it. Ring claims it will last 6-12 months on a charge. If that’s true, that wouldn’t be so bad; however, I would expect it to last like 3-6 months. In my experience, when a company gives a top end battery life range, that’s how long it will last if you never use the device. All that said, I don’t know how hard it would be to move a wired doorbell to the front of your door.
Thinking of battery-powered original Ring, I don’t think opening up the mount and recharging a battery every 3-6 months would faze me. Having two doorbells (the “real” one on the side and the Ring on the door frame) probably would bug me more than a little. It did not occur to me to move the existing doorbell, just to install the Ring in the new location on or near the door.
In fact, just this week I had the power go out at my home, which is also where my office is. I had deadlines to meet, so I decided to go to a coffee shop where I could work and fill up on caffeine. It wasn't until I walked into my garage that I remembered I had to manually open the garage door, disconnecting the door from the chain drive. My particular garage door opener wouldn't let me reconnect the door and the chain drive, locking it in place, so I was stuck with a garage door that anyone could lift open with ease.
Mair, I installed the Spotlight Cam and have been running it for a few days. I updated the content above, and I’m working on a separate review (which I will publish after Thanksgiving). So far it’s fine. There are some limitations with the Solar version, which is the same as the Battery version. One, you can’t create Activity Zones, that is limited to the Wired version only. Two, you can’t schedule the lights. The lights will turn on when motion is detected and you can trigger them manually, but that’s it. I’d say that the motion detector performance is on par with the Ring Video Doorbell. It includes the same feature that allows you to adjust motion sensitivity. There is no way to weed out false alarms, and sometimes I get alerts if the wind blows too hard. The camera wakes up fast, faster than my doorbell. The video quality is just okay. It doesn’t look like 1080p to me, it looks like 720p. Two-way talk works well. I was surprised that the cameras don’t play together. For example, if my doorbell detects an alert, I can’t trigger Spotlight to record. Spotlight doesn’t work with IFTTT so it’s not possible through their service, and though it works with Stringify, you can’t create this sort of relationship between cameras using Stringify. What else do you want to know?
Device Theft Optional Wall Mount Optional Wall Mount Screwed in using proprietary screws, Ring will replace stolen devices. Depends on the Mount – Quick Mount easier to steal, Security Mount is a more permanent solution. Easier to steal. The power adapter twists off and the Nest Cam can be removed from the magnetic base by pulling. Secure Mount (Sold Separately)
While setting the system up, my motion sensor got hung up and wouldn't stop detecting motion. I had to reset it, which I did through the app, but since it was part of the kit, the process was a little different than the app stated. This was a minor annoyance, but worth noting that if you ever run into an issue with any of the pieces that come with the kit, you'll need to do a full reset of that piece so that the base station can see it again.
It would have been convenient to have a device like a key fob for the Ring Alarm, as running to find the keypad or navigating the app to turn off the alarm takes a few seconds too long, but one does not currently exist. However, arming and disarming the system is relatively straightforward.  I just had to dig through the paper manual to figure out how to correctly enter my PIN to change modes.
3. Both Arlo and Nest have a lag from time to time. There are moments when I pull out my phone to stream Nest and it just spins and spins. I have to hard close it and then reopen the app. When it’s working, I can usually access footage in about 4 seconds. Arlo takes about 8 seconds to wake. There is also a 4 second difference between what you see on your phone and what’s happening in real life. WiFi will really depend on the speed and quality of your internet connection at home. I would suggest performing a quick test to see your current upload/download speeds.
The Alarm system does not have as many bells and whistles as Nest’s system, nor does it have some of the conveniences Nest provides. But at $199 for the starter bundle, which includes the necessary hub, a keypad, a motion detector, a contact sensor for doors or windows, and a range extender, plus $10 per month for professional monitoring, Ring’s system is significantly cheaper than Nest Secure (which was just recently reduced to $399 for its starter kit) and is one of the least expensive home security systems you can purchase.

Swann Smart Security Camera is an indoor/outdoor battery powered security camera that works without a base station. It’s most similar to Reolink Argus and Canary Flex. The camera records in 1080p FHD, offers a 120° field of view, night vision, and is IP65 rated for outdoor use. Unfortunately, it doesn’t work with any third-party devices and it lacks intelligent features to reduce false alarms. The camera boasts a feature called True Detect™, but that’s just a fancy marketing term for PIR motion sensor. The camera’s best feature is free local and cloud storage. From the app, you can playback seven days worth footage stored locally. The camera also includes two days of cloud storage.

I have tested Reolink Argus and Argus 2. Both are indoor/outdoor, hubless, battery-powered cameras. The cameras do not offer cloud storage. Instead, you can purchase and add an SD card. The cameras record in FHD 1080p, offer night vision, live streaming, mobile app access, and a 130° field of view. However, they lack other features offered by Canary, Arlo, and Nest including geofencing and the ability to connect to third-party devices.
The second issue I have for the system is that there is no quick exit feature. For the entire six years that I've had a security system, I have been used to being able to press a button that will give me one minute to quietly exit the house. This is important when I am leaving for work a few hours before my family wakes up for their day. The Ring system doesn't have this feature at all. When the system is armed, it has to be disarmed (which it announces) and rearmed before exiting with a delay that can be set up with your phone (it will announce this as well and will make a sound while it counts down) or can be armed from your phone after you leave (again, it will announce this with the countdown sound). You either have to chose if you want the system to count down or not. Not counting down will immediately arm it and you will have to arm from your phone if you leave and arm it on the "Home" setting while others are still there. You can adjust the sound that is emitted from the panel so that it isn't loud, but it will also make your door and window chimes use the same volume all of the time. If you have your system armed while you’re home, and the volume is down, you might not hear the system telling you that it needs to be disarmed if you forget and open a door. There is no in-between here. If you have to leave while others are still sleeping, this may be a problem for you.
Regardless of whether you go the adhesive or hardware route, Ring provides everything you need right in the box, with installation kits for each component of the system conveniently boxed and labeled to make it easy to find what you need. All you'll need if you want to use the included screws and anchors for hardware mounting are a screwdriver and a drill.
Meet Oco next generation Full HD Home Monitoring Meet Oco next generation Full HD Home Monitoring Camera with SD Card and Cloud Storage. Monitor everything you care about: your home children pets elderly parents business etc. Setup Oco2 in less than 60 seconds and access Full HD video remotely with our App. No Monthly Fees required to activate ...  More + Product Details Close
×